Table of Contents
Advertisement
WR20 Remote Commander
If the P
WR
down sequence, the Handset will revert to whatever it was
displaying prior to pressing the P
3.3 PTT key
The PTT key (Fig. 3.1 Item 2) is reserved for the operation of the
VHF Radio/Intercom (if connected). When pressed the user is able
to Transmit audio from the Handset. When released the user is able
to hear any audio received by the VHF Radio, (as long as the
squelch is open). The user cannot Transmit from the WR20 Handset
if the radio is already in the transmit mode from the main unit.
Note
If the Handset is set to any product page other than the VHF
Radio/Intercom mode, pressing the PTT key for 2 seconds will
change the WR20 to show the VHF Radio/Intercom Product.
3.4 SoftKeys
There are two SoftKeys located directly below the LCD, (Fig 3.1
Items 3 & 4). The function of each SoftKey is shown in the bottom
line of text directly above it.
When the two SoftKeys are pressed simultaneously for over 3
seconds, the MOB (Man Over Board) function is activated, if an
active Simrad navigation product is connected.
3.5 Navigation keys
The circular NavPad, (Fig. 3.1 Item 5) can operate in a variety of
modes depending on product being operated.
3.5.1 4-Way menu navigation
The
The
key is used to return to the previous menu (unless it has a
predefined function). Pressing and holding the
menus and return you to the top level menu.
Pressing the
go further into that items sub menus, (unless it already has a
predefined function).
18
/L
key is released at any time during the power
IGHTS
keys are used for picking or highlighting an item in a list.
key, (once an item is highlighted), will select it, or
/L
key.
WR
IGHTS
key will exit all
Hide quick links:
Advertisement
Table of Contents
