Setting Up The Radio; Nmea 2000 Network - Simrad RS90S User Manual

•
Mark and drill the 2 mounting holes and a further hole if necessary
for the GPS cable.
•
Install the gasket by firstly threading the attached cable through the
centre of the gasket.
•
Screw the GPS antenna to the mounting surface.
¼ Note:
Ensure the surface mounting area is clean with no dirt, old
paint or debris.
•
Run the GPS cable to the transceiver:
•
Route the cable to your VHF transceiver unit, adding any necessary
extension cables.
•
Connect the cable from the GPS antenna to the GPS connector
(SMA) on the VHF transceiver as shown in page 77.

Setting up the radio

¼ Note:
You must enter your User MMSI before the DSC functions of
this radio will work.
For full setup details, see the Setup section in chapter 8.

NMEA 2000 Network

The radio can be connected to an NMEA 2000 network using an
NMEA 2000 compliant cable (not supplied).
¼ Notes:
•
The NMEA backbone must be terminated at each end.
•
The 'drop' cable to each device must not exceed 6 m.
•
Further information on NMEA 2000 is available on the Simrad
website.
Installation | RS90S User Manual
| 83