Port Mirroring Commands - SignaMax SC30010 Cli Reference Manual

13
Local Port Mirroring Commands
port monitor

Port Mirroring Commands

Data can be mirrored from a local port on the same switch or from a remote port on
another switch for analysis at the target port using software monitoring tools or a
hardware probe. This switch supports the following mirroring modes.
Table 76: Port Mirroring Commands
Command Function
Local Port Mirroring Mirrors data to another port for analysis without affecting the data
passing through or the performance of the monitored port
RSPAN Mirroring Mirrors data from remote switches over a dedicated VLAN
This section describes how to mirror traffic from a source port to a target port.
Table 77: Mirror Port Commands
Command Function
port monitor Configures a mirror session
show port monitor Shows the configuration for a mirror port
This command configures a mirror session. Use the no form to clear a mirror
session.
Syntax
port monitor interface [rx | tx | both]
no port monitor interface
interface
ethernet unit/port (source port)
unit - Unit identifier. (Range: Always 1)
port - Port number. (Range: 1-52)
rx - Mirror received packets.
tx - Mirror transmitted packets.
both - Mirror both received and transmitted packets.
vlan-id - VLAN ID (Range: 1-4094)
– 386 –
Mode
IC
PE