Show Ip Source-Guard - SignaMax SC30010 Cli Reference Manual

show ip source-guard

show ip source-guard
binding
This command shows whether source guard is enabled or disabled on each
interface.
Command Mode
Privileged Exec
Example
Console#show ip source-guard
Interface Filter-type
--------- -----------
Eth 1/1 DISABLED
Eth 1/2 DISABLED
Eth 1/3 DISABLED
Eth 1/4 DISABLED
Eth 1/5 DISABLED
. .
.
This command shows the source guard binding table.
Syntax
show ip source-guard binding [dhcp-snooping | static [acl |
mac] |
blocked [vlan vlan-id | interface interface]
dhcp-snooping - Shows dynamic entries configured with DHCP
Snooping commands (see
static - Shows static entries configured with the
binding command.
acl - Shows static entries in the ACL binding table.
mac - Shows static entries in the MAC address binding table.
blocked - Shows MAC addresses which have been blocked by IP
Source Guard.
vlan-id - ID of a configured VLAN (Range: 1-4094)
interface - Specifies a port interface.
ethernet unit/port
unit - Unit identifier. (Range: Always 1)
port - Port number. (Range: 1-52)
Command Mode
Privileged Exec
Example
Console#show ip source-guard binding
MAC Address IP Address
----------------- --------------- -------------- --------- ---------
Chapter 9
ACL Table
Filter-table Max-binding
------------ -----------
ACL
ACL
ACL
ACL
ACL
page 273)
Type
– 296 –
| General Security Measures
IPv4 Source Guard
MAC Table
Max-binding
-----------
5 1024
5 1024
5 1024
5 1024
5 1024
ip source-guard
VLAN Interface