Ip Igmp Snooping Vlan Query-Interval - SignaMax SC30010 Cli Reference Manual

ip igmp snooping vlan
query-interval
To resolve this problem, the source address in proxied IGMP query and report
messages can be replaced with any valid unicast address (other than the
router's own address) using this command.
Rules Used for Proxy Reporting
When IGMP Proxy Reporting is disabled, the switch will use a null IP address
for the source of IGMP query and report messages unless a proxy query
address has been set.
When IGMP Proxy Reporting is enabled, the source address is based on the
following criteria:
◆ If a proxy query address is configured, the switch will use that address as
the source IP address in general and group-specific query messages sent
to downstream hosts, and in report and leave messages sent upstream
from the multicast router port.
If a proxy query address is not configured, the switch will use the VLAN's
◆
IP address as the IP source address in general and group-specific query
messages sent downstream, and use the source address of the last IGMP
message received from a downstream host in report and leave messages
sent upstream from the multicast router port.
Example
The following example sets the source address for proxied IGMP query
messages to 10.0.1.8.
Console(config)#ip igmp snooping vlan 1 proxy-address 10.0.1.8
Console(config)#
This command configures the interval between sending IGMP general
queries. Use the no form to restore the default.
Syntax
ip igmp snooping vlan vlan-id query-interval interval
no ip igmp snooping vlan vlan-id query-interval
vlan-id - VLAN ID (Range: 1-4094)
interval - The interval between sending IGMP general queries.
(Range: 2-31744 seconds)
Default Setting
125 seconds
Command Mode
Global Configuration
Chapter 21
– 509 –
| Multicast Filtering Commands
IGMP Snooping