Table of Contents
Advertisement
™
Signamax
065-7921PoE 12-Port 10/100/1000BaseT/TX Web Smart PoE Switch
2-1-3-1. Configuring Management Agent of 12 Gigabit Web Smart Switch with PoE
through Ethernet Port
There are two ways to configure and monitor the switch through the switch's Ethernet
port. They are Web browser and SNMP manager. The user interface for the last one is NMS
dependent and does not cover here. We just introduce the first type of management interface.
Web-based UI for the switch is an interface in a highly friendly way.
Assign a reasonable IP address,
For example:
IP = 192.168.1.100
Subnet Mask = 255.255.255.0
Default Gateway = 192.168.1.254
• Managing 12 Gigabit Web Smart Switch with PoE through Ethernet Port
Before you communicate with the switch, you have to finish first the
of the IP address or to know the IP address of the switch. Then,
follow the procedures listed below.
1. Set up a physical path between the configured the switch and a PC by a
qualified UTP Cat. 5 cable with RJ-45 connector.
Note: If PC directly connects to the switch, you have to setup the same subnet
mask between them. But, subnet mask may be different for the PC in the
remote site. Please refer to Fig. 2-6 about the 12 Gigabit Web Smart Switch
with PoE default IP address information.
2. Run web browser and follow the menu. Please refer to Chapter 4.
24 Gigabit Web Smart Switch
Default IP Setting:
IP = 192.168.1.1
Subnet Mask = 255.255.255.0
Default Gateway = 192.168.1.254
Ethernet LAN
16
Fig. 2-6
configuration
Advertisement
Table of Contents
