Port - SignaMax 065-7707 User Manual

Press "OK" to finish the operation, or press "Cancel" to cancel.
* If you restore factory setting, the IP parameters of the switch will also be reset to factory
setting.

4.3.2 Port

111111111111111111111111111111111111111111111111111111111111111
Port management includes Port Setting, Port Monitor, Monitor Mode, Port Description, Port
Statist, Port Status, Port Rate, Storm Control.
4.3.2.1 Port setting
Fig 4-15 Port setting, (IEEE802.1 Q Tag VLAN mode)
Port Enable: "Enable" denotes the port is useable (default), " Disable", denotes the port is
unusable. If the port is disabled the switch will discard the packets from this port.
Flow Control: "Enable" denotes this function is in use, "Disable" denotes this function is
not in use.
Auto Negotiation:
You can choose:
Auto：
10M ／HD：10M Half Duplex
10M ／FD：10M Full Duplex
100M ／HD：100M Half Duplex
100M ／FD：100M Full Duplex
Drop Untag-Frame: when" Enable", the frame without Tag header will be dropped. You can
set up only in IEEE802.1 Q Tag VLAN mode.
Default VLAN ID: default VID, you can only set up in IEEE802.1 Q Tag VLAN mode.
Default VLAN ID is given to the Untag frame received by the port.
Illumination:
When you change the port Number, the web page will switch to the port you choose.
When the switch is working in port-base VLAN mode or VLAN function is disabled, "Drop
Fig 4-14
1111111111111111111111111111111111111111111111111111111111111111
19