DT SWISS F 535 ONE Technical Manual page 26

Hide thumbs Also See for F 535 ONE:

12. Put on the cable housing (2) and the cable adjuster (1).

• Only cable housings with an outer diameter of 4 mm must be used.

• Slide the cable housing through the cable holder on the backside of the fork crown (A).

• Before and after the cable adjuster (1) there must be at least one short piece of cable

housing.

13. Switch the remote lever to position "OPEN" and insert the cable through the cable housing

(2).

14. Place the cable around the remote wheel and clamp it with the clamping screw. Tighten the

clamping screw with a maximum torque of 1.3 Nm.

• The clamping screw must be positioned in one of the five holes so that the cable wraps

around the remote wheel as far as possible.

• The three driving modes "OPEN", "DRIVE" and "LOCK" must be freely adjustable.

• The end of the cable must not touch the incoming cable (3).

• The end of the cable must be cut as close as possible to the clamping screw.

• Do not use a cable end cap.

15. Adjust the cable.

• Switch to "DRIVE" mode using the remote lever.

• Check that the markings (4) on the remote wheel and the fork crown match.

• If necessary, adjust the cable tension via the cable tension adjuster until both markings

match.

16. Put on the cover on the damping side (5) and tighten the fixing screw with the setup tool (Torx

T10) handtight (max. 0.2 Nm).

Table of Contents