DT SWISS F 535 ONE Technical Manual page 24

4.4 ASSEMBLING THE REMOTE CONTROL ELEMENTS
1. Turn the lockout shaft clockwise until stop
(LOCK mode).
2. Put on the dust seal.
3. Put on the spring and the limiter cap.
→ Both the spring and the limiter cap must
be placed in the bore next to the mark
on the damping unit.
4. Put on the spring.
The lower arm of the spring must be placed
inside the bore.
5. Put on the remote wheel.
The arm of the spring must be placed inside
the bore of the remote wheel.
6. Push down the remote wheel and screw on
the nut by hand as far as possible.
24