DT SWISS F 535 ONE Technical Manual page 17

3.6 ASSEMBLING THE SPRING UNIT
1. Make sure that there is still residual oil on the seals of the spring unit. Grease the seals with
a small amount of DT Swiss Fork Oil if necessary.
2. Push the screw connection of the spring
unit as far as possible in the direction of the
piston.
3. Screw in the spring unit from the bottom
using the tool FWTXXXXXXXX014126S and
tighten with a torque of 20 Nm.
Make sure that the screw connection of the
spring unit is pushed as far as possible in
the direction of the piston.
F 535 - technical manual
FWTXXXXXXXX014126S
20 Nm
27 mm
17