DT SWISS F 535 ONE Technical Manual page 4

1.5 DT SWISS MANUAL CONCEPT
The DT Swiss manuals are split into the following types of manuals:
• User Manual: Information for the end user on how to install and use the component.
• Technical Manual: Detailed information for the end user and the dealer on how to maintain the
component, spare parts and technical data.
1.6 USING THIS MANUAL
The steps described in this manual must be carried out in the order they are shown. If steps are ignored or
executed in a wrong order, the function of the component cannot be guaranteed.
Instructions begin with the table «Preparatory Steps» and end with the table «Closing Steps». The instructions
in these tables must be carried out.
1.7 GENERAL MAINTENANCE INFORMATION
Unless otherwise specified, moving parts, threads, O-rings and seals must be greased before assembly.
CLEANING
For an optimal result of the maintenance works, every component that will be disassembled must be cleaned.
Only use cleaners which do not damage the components. Especially the cleaning of O-rings and sealings
requires mild cleaners. Observe the instructions for use of the respective cleaning agent.
DT Swiss recommends the following cleaning products:
• Motorex Rex
• Motorex Swissclean
• Motorex OPAL 2400, 3000 OPAL, OPAL 5000
Use soap water or similar mild cleaners for external cleaning.
TOOLS
To ensure a damage-free mounting and dismounting of the components, only use the tools which are
mentioned in this manual. Special tools are indicated at the beginning of a chapter in the table "Required
material".
The use of different tools is at the discretion of the user. If components are damaged by the usage of differing
tools, the user is liable.
DT Swiss special tools are precision tools. Damage-free mounting and dismounting of the components can
only be ensured if the tools are working properly and if the conditions of the tools are perfect. Always keep the
tools in their original packaging or adequate devices to save them from damages.
4