D-Link DES-3326SR User Manual page 223

DES-3326SR Layer 3 Fast Ethernet Switch User's Guide
The following fields can be set:
Parameter Description
Interface Name
TX Mode
<Disabled>
RX Mode
<Disabled>
Password
Authentication
State
The name of the IP interface on
which RIP is to be setup. This
interface must be
configured on the Switch.
Toggle among Disabled, V1 Only, V1
Compatible, and V2 Only. This entry
specifies which version of the RIP
protocol will be used to transmit RIP
packets. Disabled prevents
transmission of RIP packets.
Toggle among Disabled, V1 Only, V2
Only, and V1 and V2. This entry
specifies which version of the RIP
protocol will be used to interpret
received RIP packets.
prevents the reception
packets.
A password to be
authenticate communication
between routers on the network.
Toggle between Disabled
Enabled to specify that routers on
the network should us the Password
above to authenticate router table
exchanges.
Toggle between Disable and Enable
to disable or enable this RIP interface
on the switch.
211
previously
the
Disabled
of RIP
used to
and