Steps For Finalizing The Installation - DaVinci Category 2 Owner's Manual

96

Steps for Finalizing the Installation

1. Before installing the glass, purge the gas line. This allows gas to be detected once it enters the firebox.
2. Leak test all the gas joints.
3. Follow the instructions on page 93 for "When to Install the Glass".
4. Start the fireplace.
5. Check the air shutter following the directions below.
Air Shutter Adjustment
There are several burners inside the fireplace (one burner for each foot of burner length). Each burner has its
own air shutter. The air shutters are pre-adjusted at the factory for the fuel being used and probably do not
need further adjustment. If the flames are sooty or blue and short, follow the directions below.
a) Let the fireplace burn for 20 minutes.
b) Check the flame height. Each center flame should be 9" to 12" tall at the highest point. Individual
flames may have a different pattern, but the overall height should be similar from left to right.
NOTE: The flames will look different when the crushed glass is installed. Make sure the crushed
glass is removed directly above the cluster of burner holes (see "Crushed Glass Installation").
c) If adjustment is needed, the fireplace will need to be shut off and allowed to cool. Remove the front
outer piece of glass. Remove the media tray directly behind the glass to access each air shutter (see
illustration below).
FLAMES SOOTY – Open the air shutter an additional 1/8" (3mm)
FLAMES SHORT AND BLUE – Close the air shutter an additional 1/8" (3mm)
d) Restore the fireplace to the correct configuration and verify the flames (step "a" and "b" above).
6. Give this manual to the home owner for future reference and fully explain operation of this fireplace.
7. Turn the appliance off and install the crushed glass.
© Travis Industries
Installation
6/19/18 - 1418
(for qualified installers only)
Loosen this screw then
rotate the air shutter to
adjust the air shutter.
DaVinci-Cat2+