DaVinci Category 2 Owner's Manual page 28

28
Remove Baffle and Access Panels
The fireplace utilizes a baffle above the firebox to regulate air flow. Remove the baffle by lifting it up,
tilting the front edge down, and moving the baffle out of the fireplace (see "a" below). .
EACH BAFFLE IS UNIQUE LEFT TO RIGHT AND MODULE TO MODULE: Each DaVinci
fireplace is shipped with a baffle unique to the configuration is is specified for. If the baffle is
put in backawards or in a different module, the fireplace will not operate correctly.
After removing the baffle, note its orientation. The baffles have markings on top that denote its
location. The center mark denotes the module (L for left module, R for right module). The
marks on the ends denote which end goes to the left ("L") and right ("R"). NOTE: The fireplace
module always has the gas control valve to the front.
EACH BAFFLE IS WIRED FOR OVERHEAD LIGHTING – TAKE CARE TO PREVENT
DAMAGE TO THE WIRING.
See-Through, Pier, & Island Configurations Remove the upper Titan Lock access panel (see "b" below).
Remove the lower Titan Lock access panel (see "c" below). Repeat this process ("b" and "c") for the
opposite side (disregard step "d").
Single-Sided, Bay, & Side Configurations Remove the upper Titan Lock access panel (see "b" below).
Remove the lower Titan Lock access panel (see "c" below). Remove the internal rear access (see step
"d" below).
a
© Travis Industries
Installation
Place the baffle near the
burner area. It may be
tilted back to additional
access below burner.
6/19/18 - 1418
(for qualified installers only)
b
c
d
DaVinci-Cat2+