Connecting The Exhaust Damper Harness To The Fireplace - DaVinci Category 2 Owner's Manual

58

Connecting the Exhaust Damper Harness to the Fireplace


This fireplace uses a damper near the power vent blower to prevent air from flowing through the
fireplace when the fireplace is off.

The exhaust damper harness is available in various lengths (see page 19 for details).

Route the exhaust damper harness through the cover plates and attach to the molex connector on
the fireplace as shown below.
HINT: Keep the low voltage cover plate disconnected until all wiring to the fireplace is attached. You
may also wish to leave the strain reliefs/clamps loose until the cover plate is ready to be attached.
Use pliers to compress the
strain relief when inserting or
removing it from the hole.

The opposite end of the damper harness attaches to the power vent assembly (see "Wiring the Power
Vent Assembly" for details).
© Travis Industries
Installation
Damper Harness
6/19/18 - 1418
(for qualified installers only)
Exhaust
(remove to install wire)
Strain Relief
DaVinci-Cat2+