DaVinci Category 2 Owner's Manual page 94

94
Attaching the Suction Cups to the Glass Panes
NOTE: Make sure the glass and suction cups are clean before attaching the suction cups. These
surfaces must be clean and dry for the suction cups to work properly.
NOTE: The larger glass panes may require an additional helper. We recommend using 2 people with 4
suction cups when handling long glass panes (over 5' long, especially 20" tall version).
(a) Place one suction cup onto the glass panel. Press the suction button repeatedly until the red line
on the suction cup submerges into the handle. This indicates proper vacuum.
(b) Repeat step "a" for the remaining suction cups. NOTE: The suction cups have a lever opposite the
suction button. This lever releases air, allowing the suction cup to disengage from the glass. DO
NOT PRESS THIS LEVER UNLESS YOU ARE RELEASING THE SUCTION CUP.
Air Release Lever
(c) Verify the suction cups are properly aligned and the red line is submerged before lifting the glass
(see photos below).
© Travis Industries
Installation
Red Line
Note how the red line is submerged
6/19/18 - 1418
(for qualified installers only)
DaVinci-Cat2+