Connecting The Power Exhaust Damper Harness To The Fireplace - DaVinci Category 1 Owner's Manual

30

Connecting the Power Exhaust Damper Harness to the Fireplace


This fireplace uses a damper near the power exhaust to prevent air from flowing through the fireplace
when the fireplace is off.

The power exhaust damper harness is available in various lengths (see page 13 for details).

Route the power exhaust damper harness through the cover plates and attach to the molex connector
on the fireplace as shown below.
HINT: Keep the cover plates disconnected until all wiring to the fireplace is attached. You may also
wish to leave the romex clamps loose until the cover plates are ready to be attached.
Power Exhaust Power Out
Electrical Input
Damper Harness
Use pliers to compress
the strain relief when
inserting or removing it
from the hole.

The opposite end of the damper harness attaches to the power vent assembly (see "Wiring the Power
Exhaust Assembly" for details).
© Travis Industries
Installation
Power Exhaust
(remove to install wire)
(for qualified installers only)
Strain Relief
Grommet
(remove to install wire)
4140805
Inner Cover Plate
1/4" Nutdriver
Outer Cover Plate
100-01384