Programming The Gate Path; Basic Programming Of The Automation's Movement - King gates STARG8 24 Installation And Use Instructions And Warnings

5.

Programming the gate path

5
Trimmer
Power
DIP 1 e 2
Start button
To start the system up, one of the following programming procedures must be carried out:
- basic programming of the automation's movement: self-learning of the manoeuvre times and of the slowdown start points.
- advanced programming of the automation's movement: self-learning of the manoeuvre times and manual setting of the slowdown start
points.
The procedure for programming the partial opening is used to modify the default opening value.
If, at the start of the following procedures, the "set", "radio" and "start" LEDs flash, it means that the programming protec-
tion has been activated – see Paragraph 16.1.
To interrupt the following programming sequences at any time, press the SET and RADIO buttons simultaneously or wait
10 seconds.
5.1 -

Basic programming of the automation's movement

Through this procedure, the control unit memorises the times and power required for opening and closing the system. In the case of automa-
tions for double-leaf gates, the control unit causes the full opening and closing of one gate leaf at a time. The slowdown points are automat-
ically set to 85% of the opening and closing path.
Prior to proceeding with the programming procedure, verify that dip-switches 1 and 2 have been correctly set.
DIP DIP-SWITCH status
DIP 1-2 ON ON
MOTOR
ON OFF
OFF ON
OFF OFF
1. MOVE THE GATE INTO ITS
INTERMEDIATE POSITION
6. THE CONTROL UNIT PERFORMS
A FULL OPENING MOVEMENT
The yellow "set" LED stays on
in the fixed mode
7. THE CONTROL UNIT PERFORMS
A FULL CLOSING MOVEMENT
The yellow "set" LED turns off
10
Set button
Radio button
Description of operation
Connected gearmotors: swinging series "Jet 24V", "Linear 24V", "Intro 24-400" or "Couper24"
Connected gearmotors: "Modus" series swing gate
Connected gearmotor: sliding series "Dynamos 24V"
Connected gearmotor: swinging series "Minimodus"
2. PRESS THE SET BUTTON
The yellow "set" LED flashes
(if not, consult Paragraph 16.1)
5. THE CONTROL UNIT PERFORMS
A FULL CLOSING MOVEMENT
The yellow "set" LED stays on
8. END OF THE PROGRAMMING
The LEDs return to the normal
operation configuration
FOR 1 SECOND
in the fixed mode
PROCEDURE
3. PRESS THE SET
FOR 1 SECOND
The yellow "set" LED turns on
in the fixed mode
4. THE CONTROL UNIT PERFORMS
A PARTIAL OPENING MOVEMENT*
The yellow "set" LED stays on
in the fixed mode