Programming The Door Path; Basic Programming Of The Automation's Movement - King gates ELEVO Instructions And Warnings For Installation And Use

6. Programming the
door path
OBSTACLE
FORCE
START
RADIO
34
DIP 1 & 2
35
To start up the system, one of the following programming procedures
must be carried out:
- basic programming of the automation's movement: self-learning of
the manoeuvre times and slowdown start points.
- advanced programming of the automation's movement: self-
learning of the manoeuvre times and manual setting of the slowdown
start points.
If, at the start of the following procedures, the "set",
"radio" and "error" LEDs flash, it means that the programming
protection has been activated – see Paragraph 14.1.
To interrupt the following programming sequences at
any time, press the SET and RADIO buttons simultaneously.
SET
6.1 - Basic programming of the
automation's movement
Through this procedure, the control unit memorizes working times
and power required for opening and closing the system.
The slowdown points are automatically set to ensure a correct
arrival to the end of gate path.
- For excluding slowdown, see paragraph 6.2.
STEP ACTION
MOVE THE DOOR TO
1
HALF WAY POSITION
PRESS THE SET BUTTON
2
FOR 1 SECOND
PRESS THE SET FOR
3
1 SECOND
THE DOOR PERFORMS
4 A PARTIAL OPENING
MOVEMENT
THE DOOR PERFORMS
5 A FULL CLOSING
MOVEMENT
THE DOOR PERFORMS
6 A FULL OPENING
MOVEMENT
THE DOOR PERFORMS
7 A FULL CLOSING
MOVEMENT
THE DOOR PERFORMS
A FULL OPENING
8
MOVEMENT WITH
SLOWDOWNS
THE DOOR PERFORMS
A FULL CLOSING
9
MOVEMENT WITH
SLOWDOWNS
END OF THE
10 PROGRAMMING
PROCEDURE
If the "FORCE" knob is adjusted, the automation's move-
ment must be reprogrammed.
The red "Error" LED flashes during the automation's
movement when a mechanical stress point is detected (this
corresponds to increased motor effort). Adjust OBSTACLE
and FORCE knobs (slightly turn them clockwise) to solve this
and check gate mechanics if necessary.
RESULT
The yellow "set" LED
flashes (if not, consult
Paragraph 14.1)
The yellow "set" LED turns
on in the fixed mode
The yellow "set" LED stays
on in the fixed mode
The yellow "set" LED stays
on in the fixed mode
The yellow "set" LED stays
on in the fixed mode
The yellow "set" LED stays
on in the fixed mode
The yellow "set" LED turns
off
15