Table of Contents
Advertisement
1
Camera Installation
1.3
The FB-Series O camera is an infrared thermal imaging camera intended for indoor or outdoor
security applications while installed in a fixed location. The camera mounting must support up to 5.4
lbs (2.5 kg). Refer to
from FLIR Systems, Inc.
1.3.1
The FB-Series O camera can be installed with an analog or digital (IP) video output (or both). Analog
video requires a connection to a video monitor or an analog video matrix switch. The camera can be
powered using Power over Ethernet (PoE) or with a conventional 24 Vac or 12 Vdc power supply. For
a PoE connection, an accessory PoE power supply (also called a PoE injector) is required if the
camera is not connected to a PoE switch. The maximum Ethernet cable run is 100 meters including
the PoE power supply. In installations using PoE power and IP video, only a single Ethernet cable to
the camera is required. The FB-Series O camera is a Powered Device compliant with the IEEE
802.3af-2003 standard.
In installations using analog video and conventional power, an RG59U coaxial cable and a power
cable are installed. It is recommended an Ethernet cable should also be installed for camera
configuration and troubleshooting. The FB-Series O camera does not support serial communications.
1.3.2
The FB-Series O camera package includes these standard components:
•
Fixed Camera Unit with sun shield and cable pigtail
Power terminal block, if not using PoE
•
•
Accessory terminal block—not supported
•
Five plastic screw anchors
•
Five screws
•
Tools: Torx wrench to remove cover and
spare Torx cover screw
•
Installation Template
1.3.3
The installer may need to supply the following items as required (specific to the installation).
Power supply, 24 Vac or 12 Vdc if not using PoE power for system power.
•
•
Power cable, 2-conductor, gauge determined by cable length and supply voltage,
if used for system power
•
PoE power supply or PoE switch, if used for system power.
•
Cat5e or Cat6 Ethernet cable for digital video and/or PoE for system power
•
Coaxial RG59U cables (BNC connector at the camera end) for analog video
•
Camera grounding strap, camera mount, electrical hardware, connectors, and tools
427-0064-00-12 Version 100
Installation Overview
Mounting Accessories, pg. 7
Camera Connection Options
Supplied Components
Additional Supplies
for wall and pole mounts that can be purchased
August 2017
6
Advertisement
Table of Contents
