Mudguard Adjustment - progeo EXELLE User Manual

Fig. 77

6.11 Mudguard adjustment

After adjustment,
mudguard edge should
5mm above the tyre to prevent
the user from inserting his/her
fingers between tyre
mudguard (figure 79).
With standard rear frame
It is possible to adjust the side guard, straight or mudguard, in
height and depth. The side guard is fixed with two bolts: one to the
aluminium support "S" and the another to the ring "C" that is fixed to
the frame tube.
To adjust the side guard in height:
Remove bolt and nut "A" and loosen the bolt "B" (3 and 4 mm
Allen key and 8 mm spanner).
Fig. 78
the
be
and
(figure 80)
Now it is possible to slide the ring "C" along the frame to the
desired height.
Fix the bolt "B".
Position the side guard and fix the bolt and nut "A" in one of
the three slots of the support "S".
It may be necessary to drill a new hole (5mm) on the side
guard.
To adjust the side guard in depth:
Loosen the bolt and nut "A" and remove the bolt "B" (3 and 4
mm Allen key and 8 mm spanner).
Slide the side guard along the slot of the support "S" until the
desired depth.
Tighten the bolt and nut "A".
On the side guard, drill a new 6 mm hole aligned with the one
of the ring "C".
Fix the bolt "B".
Fig. 79
Fig. 80
EXELLE 39