Backrest Height Adjustment - progeo YOGA User Manual

43 Locknut DIN 982 Inox M5
44-46 Backrest upholstery
47 Round plastic cap
48 Handle grip
49 Conical washer 5x46x3
50 Screw TSC DIN 7983 Inox 4.8x16
51 Bolt TB-EI M6x8
52 Bolt TPS-EI DIN 7991 Inox 5x18
53 Bolt TPS-EI DIN 7991 Inox 5x14
54 Side guard
55 Locknut DIN 985 Inox M5 short
56 Front fork
57 Brake
58 Headless bolt M8
59 Footplate
60 Bolt TC-EI short DIN 7984 8.8 5x30 w. z.
61 Rear wheel
62 Calf strap
63 Seat canvas
64 Seat canvas rail

6.3 Backrest height adjustment

8
It is possible to adjust the back height in 1.5cm intervals. Remove
the backrest upholstery and slide up or down up the protecting
sleeves along the tube until the fixing screws are visible. Using a
3mm Allen key and a 8 mm spanner, remove screws "B" and the
4
1
2
2
12
4
12
8
4
1dx+1sx
10
1dx+1sx
1dx+1sx
4
1
2
2
1
1
2
(figure 45)
Fig. 45
corresponding nuts and washers "B
both sides of the wheelchair. Raise or lower the back to the desired
height. Replace the screws into the nearest pre-drilled holes and
tighten.
When adjusting the backrest height make sure that the
height on the left is the same as the on the right.
After carrying out the adjustment make sure that the
screws and nuts are securely tightened.
6.4 Rear wheel adjustment
It is a very important adjustment to set the right configuration of the
wheelchair. It is possible to adjust both in height and in depth.
Height adjustment
The rear wheel can be adjusted by moving the receiver in either one
of the seven hole on the plate.
Remove the rear wheel (see chapter 5.5 "Quick release rear
wheels")
Remove the receiver "B" (22mm spanner) and its nut and
washer "B " (27mm spanner)
1
Insert the receiver in another hole of the plate.
Fasten the receiver hard
Depth adjustment
The YOGA model has 5 possible adjustments that depend on the
rear wheel plate "K" and from the lateral side.
Remove the rear wheel (see chapter 5.5 "Quick-release
rear wheels".)
Remove the two screws "A" ( 5 mm Allen key) and
corresponding nuts "A1".
Move forward or backward the rear wheel plate "K" until
". Repeat the procedure for
1
(figure 46)
YOGA 28