progeo EXELLE User Manual page 41

Such supports, that are assembled both on the right and on the left
hand side, allow the assembling of the swing away armrests,
transit wheels, anti-tip wheels, tipping aids and crutches
See table 3 for the possible combinations.
Table 3 :Possibile complete combinations
Right support
Hole Bdx Hole Adx
1
Armrest Transit wheel
2
Armrest Anti tip wheel
3
Armrest Anti tip wheel
4
Armrest Crutches support
5
Tipping aid Transit wheel
6
Crutches support Transit wheel
7
Crutches support Transit wheel
7.1 Height adjustable
armrests
(figure 82)
The swing away armrests are inserted into the accessory support
"S" with system:
1 with steel support with safety lock (figure 82), or
2 with simple aluminium support (figure 84) (available only with
standard rear frame).
Both systems allows the armrest to be
outwardly as to make moving in and out of the wheelchair easier.
The armrest can be adjusted in height.
With the system 1 (figure 82)
a 8 mm spanner) the fixing screws "A", then raise or lower the
armrest by sliding it up or down the support "B" until the desired
height is reached. It is also possible to move the support "S" and fix
it in a different position along the pre-drilled holes on the frame, in
Left support
Hole Bsx Hole Bsx
Armrest Transit wheel
Armrest Tipping aid
Armrest Crutches support
Armrest Tipping aid
Anti tip wheel Transit wheel
Anti tip wheel Transit wheel
Tipping aid Transit wheel
removable swing
removed or rotated
remove (using a 3mm Allen key and
this case it will be necessary to remove the fixing bolts and nuts (5
mm Allen key and 10 mm spanner) and fix the support in another
support.
position. Other bolts and nuts may be necessary. After adjusting
the height, re- tighten the screws "A" in the nearest pre-drilled hole.
With the system 2 (figure 84) the adjustment is possible only by
moving the support "S" along the frame.
Fig. 82 System 1
away
To facilitate transfers, it is possible to rotate the armrest by 180° or
simply remove it completely.
To rotate the armrest, lift it enough to free the safety system
(system 1) or to free it from the support's walls
swing it outward by 180° (figure 83).
To remove the armrest, with the system
fixing pin "P" positioned in the lower part of the support "S" and
pull the armrest up (figure 85).
With the system
Insert and push down the armrest in the support hole in order to fix
it. With the system
has been reached.
With the system
Fig. 83
Fig. 85
1
2 just pull the armrest up.
1, an audible click indicates the correct position
2 the tube "T" will lean simply on the support.
EXELLE
Fig. 84 System 2
T
S
(system 2) and
first push forward the
41