progeo EXELLE User Manual page 34

making a transfer. The one piece footplates are more rigid than the
double and they are recommended for those user who has frequent
spasm or exercise a lot of force on the footplate.
Double footplate
They can be flipped up easily pulling their plate up with one hand
(fig. 55). The footplate angle can be adjusted so as to give a more
comfortable support to the user's feet.
To perform the adjustment, loosen the bolt "A" (fig. 56) (5mm Allen
key) and turn the plate clock or anti-clockwise ,as shown in the
picture, to the desired inclination. Finally tighten the bolt "A".
Fig. 55
To comply with the rule UNI EN 12183 paragraph
6.1, when double footrests are fitted it is necessary
SEAT WIDTH
to maintain the correct distance between the two
footrests when lowered:
1)The footrest distance (DIST) must not exceed
for wheelchairs used by adults
mm
2)The footrest distance (DIST) must not exceed
mm for wheelchairs used by children
Here below the correct footrest sizes based on seat
Footplate type
width are detailed
Model EXELLE
Seat width
DST
Double footplate assembly drawing
montaggio pedana sdoppiata
Fig. 56
.
.
Footplate type
33 140 x 160
36 150 x 160
39 170 x 160
42 170 x160
45 200 x 160
48 200 x160
One piece flip-up plastic footplate
This model can be raised by pulling up the footplate with one hand
(figure 57).When the footrest is lowered, make sure that the hooking
tooth is correctly inserted into the slot. To adjust the angle of the one-
piece footrest, just loosen the two bolts "A" (5 mm Allen key) (fig 58)
and turn the footrest, as indicated by the arrow, until the desired
position is reached. Finally tighten the two bolts "A".
A
35
25
Fig. 58
Fig. Fig. 57
EXELLE 34