Laser Settings; Activating The Laser; Selecting Wavelength - Savant Optical Light Source Manual

1. A warm-up period of 5 minutes or less is normally required to
ensure stable output power.
2. Ensure that connectors and patch cable ends are clean before
attaching. Be sure to connect the correct type of patch cable.
3. To avoid the risk of serious eye damage, do not look into the
laser at any time.

Activating the Laser

1. Remove dust cap and connect patch cable.
2. When the light source is fi rst powered on, the laser will not be
active. Press the wavelength (
3. Pressing
Laser Off

Selecting Wavelength

Press to select the output wavelength (nm) displayed at top left
of screen.
Available wavelengths are 850nm, 1300nm (multimode testing) and
1310nm, 1550nm (single mode testing).
Handheld Optical Light Source

Laser Settings

Note
will set the initial frequency to 0Hz.
) key to activate the laser.
Laser On
Wavelength: 1310nm
Frequency: 0Hz
Rated Output Power: -5.00 dBM
12