Automatic Wavelength Identification - Savant Optical Light Source Manual

Automatic Wavelength Identification

850nm
1300nm
1. Connect the light source to its matched optical power meter
2. On the light source, press
3. Press and hold
of the screen. This indicates that Wave ID mode is active.
4. On the power meter, press and hold
the upper right corner of the screen. Wave ID mode is now
active.
5. Press to change wavelength on light source as desired.
After 3-5 seconds, the power meter will update to match the
wavelength
6. To exit Wave ID, press and hold
light source, press and hold
(0Hz).
Wave ID Mode and Auto Frequency Detection cannot operate
at the same time.
Handheld Optical Light Source
Light Source
until --AU appears on the upper right corner
Note
15
to activate laser.
until --AU appears on
on the power meter. On the
to return to continuous wave
1310nm
1550nm