1.
General
A.
This procedure defines the method required to check for delamination of composite structures using the coin tap method.
2.
Inspection
A.
Coin Tap Inspection.
(1) Establish a grid on each surface 1.5 inches by 1.5 inches (38.1 mm by 38.1 mm) using an erasable marker.
NOTE:
(2) Tap the composite panel with a coin at each grid point.
(3) Possible delamination damage should be indicated by a distinct change in coin tap sound.
(4) If delamination damage is detected, map the damage area by tapping at lesser intervals.
Copyright © Textron Aviation Inc.
Retain printed data for historical reference only. For future maintenance, use only current data.
COIN TAP INSPECTION
Certain structures may require a smaller grid. Instructions in a procedure take precedence.
FOR TRAINING PURPOSES ONLY
ISSUE 02 , JAN 2018
Model 510 Structural Repair Manual (Rev 2)
51-71-01-2 (Original Issue)
Print Date: Wed Mar 21 05:12:25 CDT 2018
Page 1 of 1