Cessna 510 Mustang Structural Repair Manual page 40

Hide thumbs Also See for 510 Mustang:

Maintenance manual (11 pages)

Table Of Contents

100

101

102

103

page of 103

/ 103
Contents
Table of Contents
Bookmarks

Table of Contents

aluminum, are not to be considered to have changed the surface of the metal.

(2) Cadmium and silver plated fasteners must not be used in or around titanium or its alloys, due to accelerated

embrittlement of titanium caused by these metals.

(3) A metal listed under two or more Group headings is compatible with all of the other metals listed in each of those

groups and with itself. However, metals listed in the same group with a material which is under two different group

headings must be considered incompatible with any of the other metal listed in the second group.

NOTE:

(4) For steels, refer to note at the bottom of Table 3.

Table 4. Recommended Dissimilar Metals Protection

Group From Table 2I

Temperature Range

Interior/Exterior

Group I below 250°F (120

°C) Interior

Group I below 350°F

(177°C) Exterior

Group II below 250°F

(120°C) Interior

Group II 250 to 350°F (120

to 177°C) Interior

Group II below 350°F

(177°C) Exterior

Group III Below 350°F

(177°C)

Group IV Below 350°F

(177°C)

Group IV 350 to 500°F

(177 to 260°C)

Group IV

C. Protective Treatment for Fastener Installation

Retain printed data for historical reference only. For future maintenance, use only current data.

Chrome plate is listed under Groups C and D, so it is compatible with a total of 19 other metals.

But the other metals in group C, such as Martensitic stainless steels, are incompatible with all

of the other metal listed in Group D.

Not Exposed to Fuel

Anodize or Protective Treatment and apply

Corrosion Protection Primer

Anodize or Protective Treatment and apply

Corrosion Protection Primer

Aluminum - chemical film and apply

Corrosion Protection Primer Other Group II

- Solvent wipe, manual deoxidize and

apply Corrosion Protection Primer

Aluminum - chemical film and apply

Corrosion Protection Primer Other Group II

- Solvent wipe, manual deoxidize and

apply Corrosion Protection Primer

Aluminum - chemical film and apply

Corrosion Protection Primer Other Group II

- Solvent wipe, manual deoxidize and

apply Corrosion Protection Primer

Lead - sandpaper as needed,

pretreatment prime, apply Corrosion

Protection Primer.

Nickel and diffused nickel, cadmium -

solvent wipe, abrasive clean and apply

Corrosion Protection Primer.

Stainless steel and tungsten - solvent

wipe, abrasive clean and apply Corrosion

Protection Primer

All but graphite. Solvent wipe, abrasive

clean and apply Corrosion Protection

Primer

All but graphite. Solvent wipe, abrasive

clean and seal with RTV 106

Graphite composites. Layer of 181

fiberglass bonded to graphite

FOR TRAINING PURPOSES ONLY

ISSUE 02 , JAN 2018

Model 510 Structural Repair Manual (Rev 2)

51-20-01-0 (Original Issue)

Exposed to Fuel

Anodize or Protective Treatment and apply

Fuel and Corrosion Protection Primer

Anodize or Protective Treatment and apply

Fuel and Corrosion Protection Primer and

topcoat with urethane enamel