Daily Maintenance; Got; Periodic Maintenance - Mitsubishi Electric C80 series Maintenance Manual

C80 Series Maintenance Manual
2 Daily Maintenance and Periodic Maintenance
2Daily Maintenance and Periodic Maintenance
Maintenance is categorized into daily maintenance items (items to be carried at set intervals) and periodic maintenance
items (replacement of parts when life is reached).
Some parts may not function in a hardware manner when the life is reached, so these should be replaced before the life is
reached.
For details of the maintenance on the GOT, refer to "GOT2000 Series User's Manual (Hardware)" (SH-081194ENG).
For details of the maintenance on the PLC, refer to "MELSEC iQ-R Module Configuration Manual" (SH-081262ENG).
For details of the inspection and maintenance of the drive section, refer to the instruction manuals for each drive unit.

2.1 Daily Maintenance

2.1.1 GOT

The following describes the items that must be maintained or inspected daily.
Inspection item
Dirt on the protective sheet
Foreign material adherence Visual check
Use the GOT always in a clean condition.
To clean the GOT, wipe the dirty part with a soft cloth using neutral detergent or ethanol.

2.2 Periodic Maintenance

There are no durable parts for CNC CPU module.
Check periodically if the usage environment is within the range of the specified environment conditions.
For the details of the specifications of GOT, I/O unit, etc., refer to the manuals listed in the "3 List of Configuration" in "C80
Series Connection and Setup Manual".
For the drive unit specifications, refer to the specification manual for the drive unit you are using.
IB-1501454-C
Inspection method
Visual check
12
Criterion
Not outstanding
Must not be attached
Corrective action
Replace
Remove and clean