Printer Display Messages - Neopost AS-940 Operating Manual

Printer Display Messages

MESSAGE
Printer Offline
ENTER for Paper Feed
Printer Online
Waiting for Data
Printer Offline
Data Ready to Print
JAM: Reprint Lost Pieces
JAM: Check Printer Setup
PAUSE: Waiting for Data
PAUSE: Off-Line Pause
PAUSE: Timed Pause-Wait
Out of Paper
Transport Time-Out
© 2009 Neopost USA Inc. All rights reserved.
DESCRIPTION
Pressing the ENTER key will
put printer into the Paper Feed
mode.
Printer is online, but has not
received any data to print.
Printer is offline and has
received data to print or still has
data present from previous job.
Printer has detected a paper jam
while online, printing records.
Correct problem then reprint
lost/damaged pieces.
Printer has detected a paper jam
while in Paper Feed or Test Print
mode.
Printer is waiting for data from
the computer, or needs more
time to receive/process data.
Printer received an "Off-Line"
PAUSE (tray break) command
from the software.
Printer was sent a Timed Pause
(tray break) command via
software.
No Paper Detected during
feeding cycle.
The printer has timed out and
has stopped the transport.
No data, no paper, no operator
response, etc... for >5 minutes.
SECTION 5
TROUBLESHOOTING
SOLUTION
This feature can be used to
check for proper media transport
setup/adjustment.
Send data to printer via
software/computer.
Put printer online then press
ENTER to start the feeding and
printing process.
Clear Paper Jam.
Check separation adjustment
Check paper size (width) setting
in software to be sure it matches
actual piece width.
Clear Paper Jam.
Check separation adjustment
Use a media length that matches
size of currently set paper length
(length previously set via
software or TEST image). TEST
image= #10 env.
When more data is sent from
computer, or printer finishes
receiving/processing data then it
will automatically continue.
Press ONLINE key to continue.
Printer will automatically
continue when time expires.
Add material to the printer.
Make sure the material is
passing over the paper sensor.
Make sure material is feeding.
Press appropriate key to
continue.
45