Configuration Software And Utilities; Hot Keys; Configuration Utilities - Intel SDS2 Product Manual

4 Configuration Software and Utilities

This chapter describes the Power-On Self-Test (POST) and server configuration utilities. The table
below briefly describes the utilities.
Table 4.

Configuration Utilities

Utility
BIOS Setup
System Setup Utility
(SSU)
FRUSDR Load Utility
BIOS Upgrade Utility
Firmware Update Utility
Using the Adaptec SCSI
Utility

Hot Keys

Use the keyboard's numeric pad to enter numbers and symbols.
Table 5.

Hot Keys

To do this:
Clear memory and reload the operating
system this is a system reset.
Secure your system immediately.
Description and brief procedure
If the system does not have a diskette drive, or the drive is disabled or
misconfigured, use Setup to enable it.
Or, you can move the CMOS jumper on the server board from the
default setting (Protect CMOS memory) to the Clear setting; this will
allow most server configurations to boot. Then run the SSU to
configure the server.
Use for viewing and clearing the system event log, viewing the system
management FRU information, or viewing the system management
SDR repository.
Use to update the Field Replacement Unit (FRU), Sensor Data Record
(SDR), and SM BIOS (SMB) flash components.
Use to upgrade the BIOS.
Use to update the Firmware.
Use to configure or view the settings of the SCSI host adapters and
onboard SCSI devices in the server.
Press these keys
<Ctrl+Alt+Del>
<Ctrl+Alt>+hotkey (Set your hot key combination with Setup.)
Page
47
57
63
67
70
72
45