Table of Contents
Advertisement
3 Configuration Software and Utilities
This chapter describes the Power-on Self Test (POST) and system configuration utilities. The
table below briefly describes the utilities.
Table 5.
Configuration Utilities
Utility
BIOS Setup
System Setup
Utility (SSU)
EMP Console
FRUSDR Load
Utility
BIOS Update
Utility
Firmware Update
Utility
Using the
Symbios SCSI
Utility
Hot Keys
Use the keyboard's numeric pad to enter numbers and symbols.
Table 6.
Hot Keys
To do this:
Clear memory and reload the operating
system
this is a system reset.
Secure your system immediately.
Description and brief procedure
If the system does not have a diskette drive, or the drive is disabled or
misconfigured, use Setup to enable it.
Or, you can move the CMOS jumper on the system board from the default
setting (Protect CMOS memory) to the Clear setting; this will allow most
system configurations to boot. For the procedure to do this, see the section
"CMOS Jumper" in Chapter 5 in this manual. Then run the SSU to
configure the system.
Use for extended system configuration of onboard resources and add-in
boards, and for viewing the system event log, setting boot device priority, or
setting system security options.
The SSU may be run from either the Server Configuration CD or from a
DOS-bootable diskette.
Information entered via the SSU overrides information entered via Setup.
Use to access and monitor the server remotely.
Use to update the Field Replacement Unit (FRU), Sensor Data Record
(SDR), and Desktop Management Interface (DMI) flash components.
Use to update the BIOS or recover from a corrupted BIOS update.
Use to update BMC flash ROM.
Use to configure or view the settings of the SCSI host adapters and
onboard SCSI devices in the system.
Press these keys
<Ctrl+Alt+Del>
<Ctrl+Alt>+hotkey (Set your hot-key combination with the SSU or
Setup.)
Page
35
48
56
69
75
78
78
33
Advertisement
Table of Contents
