Control Entering Passcodes; Passcodes - Conair Thermolator TW-1 User Manual

TW-1, TW-2
C
ONTROL
E
NTERING
P
ASSCODES
4-16
O
PERATION
The TW-1 and TW-2 models have a security feature that pre-
vents accidental or unauthorized changes to the setpoint tem-
perature, high and low deviation limits, SPI address, and baud
rate.
If passcode protection is enabled, you must enter the correct
passcode to change these parameters. To enter the passcode:
1
Press and hold the Setpoint Select button
for 5 seconds. The control will display 1 PaS to indicate a
passcode is needed.
2
Press the Select s button until the correct
passcode appears in the display.
3
Press again to enter the passcode.
If the passcode is correct, the control displays ACC PAS
for 3 seconds. If the passcode is incorrect, the control dis-
plays rEJ PAS (rejected passcode) for 3 seconds.
4
Press Setpoint
want to change.
You have access to the system parameters until:
l The power is cycled off and on.
l The RUN or STOP button is pressed.
NOTE: Pressing the STOP or RUN key while you are
entering a passcode will abort the passcode entry
sequence.
Thermolator TW Series
to select the parameter you
UGH025-0504