Tw Control Menu - Conair Thermolator TW-1 User Manual

The TW temperature controller uses a menu system to access
different operating modes or change system parameters.
Please see the Appendix for default parameter settings and
detailed information on each of these modes and parameters
Parameter Menus
Temperature Units. Allows selection of the displayed
Uni
temperature units.
Process Variable. Allows the operator to select the
PUS
controlled temperature from the following: To Process,
From Process and Average.
Tuning the Thermolator. The controller has three pre-
configured tuning parameter sets, one of which should
PIT
allow optimum temperature control.
Control. Used to select parameters associated with
DSP
control methods.
Alarm. Used to select alarm parameters.
DDT
VT1
Vent Time 1. Cooling Valve on.
Vent Time 2. Cooling valve with pump on.
VT2
Alarm Acknowledge timer. Sets the time that an
AAT
alarm can be acknowledged and silenced without being
satisfied.
Software Version. This "read only" parameter depicts
T01
the version of software that has been downloaded into
the controller.
UGH025-0504 Thermolator TW Series
TW C
ONTROL
M
ENU
Press and hold
five seconds to access
the menus
Press to index
through the menus.
Press to index
through parameters
under each menu item.
O
PERATION
for
4-3