Conair Thermolator TW-1 User Manual page 107

The Thermolator will not operate correctly if certain factory-set
parameters are changed. Parameters should be changed only by
qualified technical personnel who are familiar with the operation of
this type of equipment.
If the Thermolator does not appear to be working correctly, verify
the parameters against the list of factory settings.
For more detailed information about these parameters and return-
ing parameters to the initial factory setup, See the Series 16C
Instruction Manual included with this instruction package.
Menu Function
SET
ASP Active Setpoint
Uni Unit of Measure
PUr Process Variable
Pit Proportional Integral Tuning
dSP Deviation from Setpoint
ddt Deviation Alarm Delay Time Period
Ut1 Vent Time Period 1
Ut2 Vent Time Period 2
AAt Alarm Acknowledge Timer
t01 Thermolator Version Release 01
SLo Slow Proportional Prop Band
nor Normal Proportional Prop Band
FSt Fast Proportional Prop Band
db Dead Band
CCt Cooling Cycle Time
Ci Cooling Integral Time Period
HCt Heating Cycle Time
Hi Heating Integral Time Period
PrS Power-Up Restart Selector
rSS Remote Setpoint Selector
PiC Proportional to Integral
Crossover Percent
UGH025-0504
User Level (1 sec)
Setpoint
Configuration Level (5 sec)
Service Level (15 sec)
Range
20-250ºF (-6.6-121.5ºC)
Read Only
ºF or ºC
to = To Temperature
Fro = From Temperature
AUG = Average Temperature
rE = Remote Temperature
SL0 = Slow
nor = Normal
FSt = Fast
0-45ºF (0-25ºC)
0-600 seconds
0-999 seconds
0-999 seconds
0-60 minutes
Read Only
0.2-180°F (0.1-100°C)
0.2-180°F (0.1-100°C)
0.2-180°F (0.1-100°C)
0-10°F (0-5.6°C)
0-60 seconds
0-999 seconds
0-60 seconds
0-999 seconds
on = Manual
oFF = Auto
oFF = Controller Setpoint Active
on = Remote Setpoint Active
0-100%
Thermolator TW Series
TW C
ONTROL
D
EFAULT
P
ARAMETERS
Default
75ºF
ºF
ºF
AUG
nor
20ºF
600 seconds
15 seconds
15 seconds
1 minute
t01
5°F
10°F
15°F
0.5°F
7 seconds
15 seconds
7 seconds
15 seconds
on
OFF
35%
A
PPENDIX
C-1