Canon HJ40x10B Operation Manual page 54

2. Mount the tripod adapter on the supporter using
the procedure below.
(The tripod adapter is supplied by the camera manu-
facturer. Be sure to also refer to the camera op-
eration manual when performing the mounting
procedure.)
2-1. Insert the two camera mounting screws
(3/8-UNC) into the tripod screw holes on the
tripod adapter, and then turn the camera
mounting knob to tighten the two screws.
2-2. Then, to stop any looseness, turn the camera
mounting lock knob to tighten and secure in
place.
3. Check that the pan and tilt mechanisms of the tripod
and the lock handle for the system center of bal-
ance are locked. Then, take the supporter where the
V-wedge board and tripod adapter were mounted in
steps 1 and 2, and mount it onto the cam head.
CAUTION: Before mounting the supporter, thoroughly read the operation manual for the tripod
and pedestal, and be sure that you fully understand how to lock and unlock the pan
and tilt mechanisms on the cam head. Then, mount the V-wedge board onto the
cam head. If you mount the supporter without locking the pan and tilt mechanisms
on the cam head, the camera, lens, or supporter can fall and be damaged or cause
an injury. Therefore, be sure to always lock the pan and tilt mechanisms in place be-
fore starting any mounting procedures.
(B) MOUNTING THE CAMERA ON THE SUPPORTER
Mount the camera on the tripod adapter where the
supporter is already mounted.
(The tripod adapter is supplied by camera manufac-
turer. For details on how to mount it, refer to the cam-
era's instruction manual.)
Camera Mounting Knobs
Camera Mounting Lock Knob
E8
Camera Mounting Screw
Mount the supporter onto
the cam head
Mount the camera on the
supporter
Tripod Adapter