Canon HJ40x10B Operation Manual page 63

Function 2. Framing Preset
●
Pressing the frame button allows you to zoom to a framing memory position (preset zoom position) from any
zoom position. The zoom speed to the framing memory position can be chosen as either the maximum speed
or the preset zoom speed (See function 3).
1. How to store the Framing memory position
Step 1. Zoom to any desired zoom position.
Step 2. Press the Frame button while holding
down the Memo button.
(Steps 1 and 2 above complete the stor-
ing of the framing memory position.)
*(NOTE): This framing memory position is differ-
ent from the shuttle shot memory position
(Refer to function 1).
The stored zoom position remains in the
memory, even after the power is turned off.
2. How to set the zoom speed to the framing memory position
The speed mode selector lever located around the Frame button is used to select one of the following
speeds.
Fast : For the maximum speed setting
Pre : For the preset speed setting
(Setting the preset speed is based on operation by function 3)
3. How to use the Frame button
Once the frame button is pressed, the zoom starts to move toward the framing memory position.
The zoom moves at the preset speed when the speed mode selector is set to Pre position, or at the
maximum speed when it is set to Fast position.
When the zoom reaches the framing memory position, it stops and remains at that position.
*(NOTE): It is not necessary to hold down the frame button until the zoom reaches the framing memory
position, as for the Shtl button. (Refer to function 1) Simply press the frame button.
4. How to cancel movement to the framing memory position or shift other zoom operations
During movement to the framing memory position, the movement can be cancelled and/or shifted to
another zoom operation by any of the following operations.
●
Pressing the frame button again stops movement to the framing memory position, and the zoom
remains at that point.
● Zoom operation with the zoom rocker seesaw can immediately take over.
● Zoom operation with the Shtl button can immediately take over.
● Zoom operation with the button (either the VTR or RET switch which is set for the speed
preset function) can immediately take over.
(Refer to Function 3. Speed Preset for details about the speed preset function.)
Memo Button
E17
Zoom Rocker Seesaw
Frame Button
Speed Mode Selector Lever