Canon HJ40x10B Operation Manual page 72

(C-3) SELECTING THE IMAGE STABILIZER OPERATING ENVIRONMENT
The default settings for behavior (switch mode) of the IS ON/OFF switch and image stabilization
direction of the image stabilizer are shown below.
Switch mode .............. Alternate operation (ALT) where the ON and OFF settings change each
Stabilization direction . Performed for both the horizontal (H) and vertical (V) directions
The following settings can also be made according to the usage environment and user preferences.
Switch mode .............. Momentary operation (MOM) where the image stabilizer is activated
Stabilization direction ... Performed for the vertical (V) direction only
Anti-vibration direction
(10-pin DIP switch 9)
H+V
(Horizontal + Vertical)
V
( Vertical)
The default setting for image stabilization is the standard characteristics (STD) which perform special processing
for fluctuation in low-frequency waves due to slow-moving camera work to minimize unnatural movements.
However, image stabilization can also be set to the maximum characteristics (MAX) for correcting frequency
fluctuation.
Horizontal anti-vibration
characteristics
(10-pin DIP switch 6)
STD
MAX
See section 5-8, DIP SWITCH SETTINGS for the setting procedures for the switch mode (SW MODE) and
image stabilization directions and correction characteristics.
time the button is pressed
only while the ON button is pressed
Switch mode
(10-pin DIP switch 8)
ALT
MOM
ALT
MOM
Button is released
Vertical anti-vibration
characteristics
(10-pin DIP switch 7)
STD
MAX
STD
MAX
IS ON/OFF
switch operation
Switches between standby and operation
Each time button
of the image stabilization for both the H
is pressed and
and V directions each time the IS switch is
released
pressed
While the button Operation of the image stabilization for both
is held down the H and V directions
Button is released Standby of the image stabilization function
Each time button Switches between standby and operation
is pressed and of the image stabilization for the Vdirection
released only each time the IS switch is pressed
While the button Operation of the image stabilization for the
is held down V direction only
Standby of the image stabilization function
Low frequencyfluctuation correction
Standard characteristics for both the H and V
directions
H: Standard characteristics
V: Maximum characteristics
H: Maximum characteristics
V: Standard characteristics
Maximum characteristics for both the H and V
directions
E26
IS function operation
characteristics