Canon HJ40x10B Operation Manual page 66

Function 3. Speed Preset Operation Diagrams
Speed Preset Function
●
When the button ( RET or VTR switch can be assigned for the speed preset function) is pressed,
●
the zoom starts to move at the preset speed and to the determined direction and stops at the zoom end.
(either narrow angle end or wide angle end).
Zoom end
Other
●
The following operations cancel the zoom movement by the speed preset operation, and shifts to other
zoom operations.
When the button ( RET or VTR switch which is allocated to this function) is pressed again, stops
●
the zoom at that position.
Zoom end
The priority is given to the zoom operation with the zoom rocker seesaw.
●
Zoom end
②
Zoom operation with the zoom rocker seesaw
The priority is given to the zoom operation with the Shtl button.
●
Zoom end
③
The priority is given to the zoom operation with the frame button.
●
Zoom end
②
The Frame button is pressed
Note : When the frame button is pressed, the zoom speed changes, according to where the speed mode
selector is set.
The zoom moves at the maximum speed, when it is set to Fast position, or at the preset speed,
when it is set to Pre position.
② The speed preset button is pressed again
③
Zoom operation with the zoom rocker seesaw
Stop
④
When the zoom rocker seesaw is released at this point, the zoom stops instantly.
Shuttle memory
position
(At the preset speed)
The Shtl button is released
Framing memory
position
(See note below)
(At the preset speed)
The speed preset button is pressed
Stop
(At the preset speed)
①
The speed preset button is pressed
(At the preset speed)
①
The speed preset button is pressed
①
The speed preset button is pressed
②
The Shtl button is held down
(Original position)
(At the preset speed)
①
The speed preset button is pressed
E20
(Example)
Any zoom position
Any zoom position
Any zoom position
Any zoom position
(At the preset speed)
Any zoom position
Zoom Position
Operation