Table of Contents
Advertisement
TPM2.0 UEFI Spec Version [TCG_2]
Allows you to select the TCG2 spec version support.
[TCG_1_2]
[TCG_2]
Physical Presence Spec Version [1.3]
Allows you to select which TCG Physical Presence Interface Specification Version
is supported by the OS. Configuration options: [1.2] [1.3]
Device Select [Auto]
Allows you to schedule an operation for security devices. Reboot your system for
the changes to take effect. Configuration options: [Auto] [TPM 1.2] [TPM 2.0]
[Auto]
3.3.3
SATA Configuration
SATA Controller(s) [Enabled]
Allows you to enable or disable SATA devices. Configuration options: [Enabled]
[Disabled]
SATA Mode Selection [AHCI]
Allows you to set the working mode of the SATA controller. Configuration options:
[AHCI] [RAID]
Port 0, Port 1, Port 2, Port 3, Port 4 [Enabled]
These items allow you to enable/disable the SATA port(s). Configuration options:
[Disabled] [Enabled]
Hot Plug [Disabled]
These items allow you to enable/disable SATA Hot Plug Support. Configuration
options: [Disabled] [Enabled]
3.3.4
USB Configuration
The USB Devices item lists auto-detected values. If no USB device is detected,
the item shows None.
Legacy USB Support [Enabled]
[Enabled]
[Disabled]
3-4
Compatible mode for Windows
Newer TCG2 protocol and event format for Windows
later.
Select this item to support both TPM 1.2 and TPM 2.0 devices
with default support of TPM 2.0 devices. If TPM 2.0 devices
are not found, TPM 1.2 devices will be enumerated.
Enables the support for USB devices on legacy operating
systems (OS).
USB devices are only available when running BIOS Setup.
8 / Windows
10.
®
®
10 or
®
MIX-Q370D1
Advertisement
Table of Contents
