Table of Contents
Advertisement
3.
Chassis / CPU fan connectors (4-pin CHA_FAN1, 4-pin CPU_FAN1)
Connect the fan cables to the fan connectors on the motherboard, ensuring
that the black wire of each cable matches the ground pin of the connector.
MIX-Q370D1
MIX-Q370D1 Fan connectors
CAUTION: Do not forget to connect the fan cables to the fan connectors.
Insufficient air flow inside the system may damage the motherboard
components. These are not jumpers! Do not place jumper caps on the fan
connectors!
4.
SATA 6.0Gb/s connectors (7-pin SATA6G_1~4)
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial
ATA 6.0 Gb/s signal cables.
MIX-Q370D1
MIX-Q370D1 SATA 6.0Gb/s connectors
IMPORTANT: When using hot-plug and NCQ, set the SATA Mode Selection
item in the BIOS to [AHCI]. See section 3.3.3 SATA Configuration for details.
Chapter 2: Motherboard information
CHA_FAN1 CPU_FAN1
2-19
Advertisement
Table of Contents
