Digital Io Port Configuration - Aaeon MIX-Q370D1 Manual

The following items appear when you set Power Mode to [ATX Type].
Restore AC Power Loss [Last State]
[Last State]
[Always On]
[Always Off]
RTC Wake system from S5 [Disabled]
[Disabled]
[Fixed Time]
[Dynamic Time]
The following items appear when Fixed Time is enabled.
Wake up day/hour/minute/second [0]
Specify the values for day/hour/minute/second.
The following item appears when Wake System with Dynamic Time is enabled.
Wake up minute increase [1]
Specify the number of minutes added to the current time before waking up
system. Input value range: [1~5]
3.3.10 Digital IO Port Configuration
The items listed in this screen configure Digital IO settings.
DIO Port1~Port4 [Output], DIO Port5~Port8 [Input]
Configuration options: [Input] [Output]
The following item appears only when you set DIO Port1~8 to [Output].
Output Level [High]
Configuration options: [High] [Low]
3-8
The system goes into either off or on state, whatever the system
state was.
The system goes into on state after an AC power loss.
The system goes into off state after an AC power loss.
Disables system wake up from S5.
The system will wake up at the specified hr::min::sec.
Configuration options: [Disabled] [Enabled] .
The system will wake up at the current time plus a specified
number of minutes.
MIX-Q370D1