Aaeon MIX-Q370D1 Manual page 22

Industrial motherboards
Hide thumbs Also See for MIX-Q370D1:
Table of Contents

Advertisement

4.
AT/ATX mode selection (3-pin AT_ATX)
MIX-Q370D1 AT/ATX mode selection
ATX mode (Default)
AT mode
5.
Chassis intrusion jumper (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
Move the jumper cap to pins 1-2 when you intend to use the chassis intrusion
detection feature.
MIX-Q370D1 Chassis intrusion connector
Pins
1-2
3-4
2-14
ATX mode
(Default)
MIX-Q370D1
Intrudor
Intrudor
No Intrudor
MIX-Q370D1
Enables the chassis intrusion detection feature
Disables the chassis intrusion detection feature
(Default)
AT_ATX
1
2
2 3
AT mode
Pins
1-2
2-3
CHASSIS
PIN1
MIX-Q370D1

Advertisement

Table of Contents
loading

Table of Contents