Mhz Out; Gpib; Lan; Device Usb - Keysight Technologies N5171B EXG User Manual

8. 10 MHz OUT

Connector female BNC
Signal A nominal signal level greater than 4 dBm.

9. GPIB

This connector enables communication with compatible devices such as external controllers, and is
one of three connectors available to remotely control the signal generator (see also
11. Device USB).

10. LAN

The signal generator supports local area network (LAN) based communication through this
connector, which enables a LAN–connected computer to remotely program the signal generator.
The LAN interface supports auto–MDIX. The signal generator is limited to 100 meters on a single
cable (100Base–T). For more information on the LAN, refer to the Programming Guide.

11. Device USB

Connector Type B
USB Protocol Version 2.0
Use this universal serial bus (USB) connector to connect a PC to remotely control the signal
generator.

12. Host USB

Connector Type A
USB Protocol 2.0
Use this universal serial bus (USB) to connect a USB Flash Drive (UFD) for data transfer. You can
connect or disconnect a USB device without shutting down or restarting the signal generator.

13. SD Card

Holds the Secure Digital (SD) nonvolatile memory card.

14. ALC INPUT

This input connector is used for negative external detector leveling.
Connector female BNC
Signal -0.2 mV to -0.5 V
Damage Levels -12 to 1 V
Keysight EXG and MXG X-Series Signal Generators User's Guide
Impedance nominally 50 Ω
Impedance nominally 100 kΩ
Signal Generator Overview
Rear Panel Overview (N5173B & N5183B)
10. LAN and
23