Fl Remote Id - Omron V680-HS63 User Manual

SECTION 2
Installation, Connections, and Wiring

FL Remote ID

Installation
To ensure full functionality of the V680-HAM42-FRT FL Remote ID, follow the instructions provided in
this section for installation.
■ Installation Site
Do not install the ID Controller in the following locations.
• Locations exposed to ambient temperatures that are not between 10 and 55C or where there are
radical temperature changes resulting in condensation
• Locations exposed to humidity that is not between 25% and 85%
• Locations subject to corrosive gas, flammable gas, dust, salt, or metal powder
• Locations that will expose the ID Controller to direct vibration or shock
• Locations exposed to direct sunlight
• Locations exposed to spray of water, oil, or chemicals
• Locations more than 2,000 m above sea level
■ Mounting in a Panel
The FL Remote ID Unit can be used at an ambient temperature range of 10 to 55C. Be sure to
observe the following precautions.
• Make sure that the Unit is provided with sufficient ventilation space.
• Do not install the Unit close to heaters, transformers, or large-capacity resistors that radiate excessive
heat.
■ Installation Method
DIN Track
V680-HAM42-FRT
OMRON
DEV
RMT
NODE No.
0
X10
SOURCE : 24VDC 0.3A
OMRON Corporation
End Plate
Mounting Hook
1. First hook the FL Remote ID Unit to part A, then press it in direction B to mount it to the DIN Track.
2. To disconnect the FL Remote ID Unit from the DIN Track, pull the mounting hook downwards, and
then lift the Unit upwards.
RFID System
26
User's Manual
TR 8 7 6 5
NORM/ERR 4 3 2 1
MODE
0 0
1 0
X10
OFF
FSM RFID
MADE IN JAPAN
End Plate
A
OMRON PFP-100N
(track length: 1 m)
is recommended.
B
65
DIN Track
End Plate
PFP-100N
PFP-M