Omron V680-HS63 User Manual page 56

SECTION 4
Functions
Setting RF Tag Service Life Warning Management
There are settings in the FL Remote ID to enable and disable RF Tag service life warning manage-
ment. To use RF Tag service life warning management, always make the settings for the FL Remote ID.
■ Setting the FL Remote ID
RF Tag service life warning management for the FL Remote ID can be enabled or disabled by using
the RF Tag Service Life Warning Bit in the I/O Allocation Table.
For details, refer to I/O Allocation Table and Signal Names and Functions.
Preparing RF Tags
To use RF Tag service life warning management, always initialize unused RF Tags.
■ Initializing RF Tags
Use the following procedure to initialize unused RF Tags if they are to be used with RF Tag service life
warning management.
(1) Disable the RF Tag service life warning management for FL the Remote ID.
(2) Write 00 hex to the eight bytes from addresses 03E0 to 03E7 hex of the RF Tag.
(3) Enable the RF Tag service life warning management for the FL Remote ID.
For details, refer to I/O Allocation Table and Signal Names and Functions.
Warning from RF Tag Service Life Warning Management
A warning will be output if RF Tag service life management warning management is enabled for the FL
Remote ID and the number of write operations is 100,000 or higher.
 Checking with I/O Allocation Table
When a warning is output with RF Tag service life warning management, the FL Remote ID will turn
ON the RF Tag Service Life Warning Bit in the I/O Allocation Table.
The Normal End Bit will turn ON, but the Error End Bit will not turn ON.
For details, refer to I/O Allocation Table and Signal Names and Functions.
RFID System
54
User's Manual
p.60, p.61
p.60, p.61
p.60, p.61