Precautions For Safe Use - Omron V680-HS63 User Manual

Introduction
Be sure to observe the following precautions to ensure safe use of the Products.
1. Do not use the Products in environments with flammable, explosive, or corrosive gases.
2. Do not attempt to disassemble, repair, or modify any Product.
3. Tighten mounting screws securely.
4. Be sure to use crimp terminals of the specified size for wiring.
5. If any cable has a locking mechanism, make sure that it has been locked before using the cable.
6. Make sure the power supplied by the DC power supply unit is within the rated power supply voltage (24
VDC +10%/15%) before using the Product.
7. Do not connect the power supply in reverse.
8. Do not allow water or pieces of wire to enter from openings in the case. Doing so may cause fire or electric
shock.
9. Turn OFF the FL Remote ID power before attaching or removing the Read/Write Antenna.
10. If an error is detected in any Product, immediately stop operation and turn OFF the power supply.
Consult with an OMRON representative.
11. Dispose of the Products as industrial waste.
12. Do not touch the product immediately after usage at high temperatures. Doing so may occasionally result
in burning.
13. If multiple Antennas are mounted near each other, communications performance may decrease due to
mutual interference. Refer to Mutual Interference between Antennas (Reference) and check to make sure
there is no mutual interference.
14. Provide sufficient ventilation space.
15. Do not install the Products near any equipment that generates a large amount of heat (such as heaters,
transformers, and large-capacity resistors).
16. Using thinner, benzene, acetone, or kerosene for cleaning may affect the resin parts and the surface of the
case. For detail, refer Chemical Resistance of the Antennas and RF Tags186 and do not use chemicals
that affect the resin parts and the surface of the case.
17. Observe all warnings and precautions given in the body of this manual.
RFID System
4
User's Manual

Precautions for Safe Use