Omron V680-HS63 User Manual page 32

SECTION 2
Installation, Connections, and Wiring
■ Power Supply Connector
Use the connector that comes with the Unit. You must provide the connecting cable.
Cable
Connector
Crimp Terminal When one line is con-
Crimping Tool
1.
Attach the crimp terminals to the sections of the cable where the
sheath has been stripped.
2.
Make sure the connector is facing the right direction and insert
each crimp terminal into the correct connector hole.
3.
Once all of the cables have been connected to the connector,
attach the connector to the FL Remote ID Unit.
Align the cable connector with the connector on the FL Remote ID Unit. Hold the
connector body and push the connector firmly into place.
Removing the Connector
Remove the connector by pressing in on the lock on the cable connector to release the lock and pulling the connector
straight out. If the connector is difficult to remove, press on the FL Remote ID Unit while pulling on the connector.
Do not connect cables to the connector after attaching the connector to the FL Remote ID Unit.
Use the recommended Power Supply (S8VS-03024, OMRON).
RFID System
30
User's Manual
Power line
nected to one terminal
Phoenix Contact
When two lines are con-
nected to one terminal
Brand Model
--- ---
FKC2.5/3-ST-5.08-RF
AI1-10RD
AI-TWIN21-10RD
CRIMPFOX UD6
Note
1.0 mm 2 (equivalent to AWG18)
---
---
---
---