Spinner Installation - Seagull Models Sparrow Hawk SEA-93 Instruction Manual

www.seagullmodels.com
M3 x 15mm.
Battery hatch.
2
Trim and cut.
Trim and cut.
1
C/A glue.
Battery.
Pen.
Install the spinner backplate, propeller and
spinner cone.
The propeller should not touch any part
of the spinner cone. If it does, use a
sharp modeling knife and carefully trim away
the spinner cone where the propeller comes
in contact with it.
Machine Screw M3x10mm.
.
1
2

SPINNER INSTALLATION.

5mm.
Needle valve.
M3 x 15mm.
Battery hatch.
13