Table of Contents
Advertisement
Previous view
5
dPMR™ OPERATION
Receiving and transmitting
D Transmitting
You can make a call to a station that has the same
Common ID. Other digital mode transceivers on the
channel will not receive the call that does not match
their Common ID.
Before making a call, wait until the channel is clear to
avoid interference.
Using [PTT]:
1. Rotate [Rotary Selector] to select a channel.
2. Push [PTT] to call a station.
3. Hold down [PTT] and speak at your normal voice
level.
4. Release [PTT] to receive.
5. Push [Clear]* to send a 'Disconnect' signal to
terminate the call.
Using the [S-Ring/C-Ring]:
1. Rotate [Rotary Selector] to select a channel.
2. Hold down [S-Ring/C-Ring] for 1 second to call a
station.
3. Hold down [PTT] and speak at your normal voice
level.
4. Release [PTT] to receive.
5. Push [Clear]* to send a 'Disconnect' signal to
terminate the call.
Using the [Call]*:
1. Rotate [Rotary Selector] to select a channel.
2. Push [Call]* to send a call request.
NOTE: After receiving a call request, a ringer sounds
on a receive transceiver.
3. Hold down [PTT] and speak at your normal voice
level.
4. Release [PTT] to receive.
5. Push [Clear]* to send a 'Disconnect' signal to
terminate the call.
* Assign the function to a programmable key by using
the CS-F29DR2
programming software
separately). Ask your dealer for details.
[PTT]
NOTE: To insure the readability of your signal:
1. After pushing [PTT], pause briefly before you
start speaking.
2. Hold the microphone 5 to 10 cm from your mouth,
and then speak at your normal voice level.
(purchase
16
[Rotary Selector]
Advertisement
Table of Contents
